Site Overlay

GIGABYTE 8I845PE RZ AUDIO DRIVER DOWNLOAD

No part of this manual may be reproduced or transmitted in any from. Then move the socket lever to the locked position while holding pressure on the center of the CPU. Page 14 Please connect the floppy drive ribbon cables to FDD. Fasten the cooling fan supporting-base onto the CPU socket on the motherboard. Memory size can vary between sockets. Apply thermal grease between the processor and cooling fan.

Uploader: Vudorg
Date Added: 10 May 2014
File Size: 49.7 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 69245
Price: Free* [*Free Regsitration Required]

For optional front USB cable, please contact your local dealer. It will blink when the system enters suspend mode.

Locate Pin 1 in the socket and look for a golden cut edge on the CPU upper gigabyye. None No floppy drive installed K, 5. Disabled Select your boot device priority by Disabled. Hold components bythe edges and trynottouch the ICchips, leads orconnectors, orother components.

8IPE-RZ (rev. ) | اللوحة الرئيسية – GIGABYTE Saudi Arabia

Table of Contents Chapter 1 Introduction To protect them against damage from static electricity, you should follow some precautions whenever you work on your computer. Enabled Enable Modem Ring on function. Sometimes youmay need to use the plastic springs to isolate the screwfrom the motherboard PCB surface,because the circuitwire maybe nearbythe hole.

  HP A1100Y ETHERNET DRIVER DOWNLOAD

To install the memory module, just push it vertically into the DIMM socket.

Gigabyte 8I845PE-RZ User Manual

No part of this manual may be reproduced or transmitted in any from. Default value Enabled Clear case open status at next boot. Trademarks Third-party brands and names are the property of their respective owners.

The hard disk will not work properly if you enter improper information for this category. The DIMM module can only fit in one direction due to the notch. Disabled Disabled this function. Click each item to install the driver manually or switch to the to install the drivers automatically. The value of the base memory is typically K for systems with Auio memory installed on the motherboard, or K for systems with K or more memory installed on the motherboard.

The red stripe of the ribbon cable must be the sam e side with the Pin1. Default value PasswordCheck System The system can not boot and can not access to Setup page will be denied if the correct password is not entered at the prompt.

  945GCDMS-6H LAN DRIVER DOWNLOAD

Have a standard USB interface.

Please connect the floppy drive ribbon cables to FDD. Install AGP Card 1.

Gigabyte 8I845PE-RZ – motherboard – ATX – Socket 478 – i845PE Series

Item Description Driver install finished!! Then move the socket lever to the locked position while holding pressure on the center of the CPU.

Date of Month Alarm: Type “N” will return to Setup Utility. Enabling the functionality of Hyper-Threading Technology for your computer system requires all of the following platform components: Default value Delay 4 Sec.

Related publications Share Embed Add to favorites Comments. This manual also for: LS Select your boot device priority by LS Enabled Enable Modem Ring on function. Do not force the CPU into the socket.

Default value Memory System power on depends on the status before AC lost.